- Chapter Objectives
- EXERCISE 3-1 Drawing a Rectangular Conference Room, Including Furniture
- Making a Drawing Template
- Polyline
- OFFSET
- EXPLODE
- ID Point
- TRIM
- Rectangle
- CHAMFER
- FILLET
- COPY and Osnap-Midpoint
- ROTATE
- POINT
- DIVIDE
- MEASURE
- OSNAP
- MIRROR
- Osnap Modes That Snap to Specific Drawing Features
- Running Osnap Modes
- Osnap Settings: Marker, Aperture, Magnet, Tooltip
- EXERCISE 3-2 Drawing a Rectangular Lecture Room, Including Furniture
- Making Solid Walls Using Polyline and Solid Hatch
- From
- BREAK
- Polyline Edit
- HATCH
- ARRAY
- ARRAYEDIT
- Distance
- Exercise 3-3 Drawing a Curved Conference Room, Including Furniture
- Polyline
- POLYGON
- Grips—Add Vertex
- Grips—Convert to Arc
- ARRAY
- Exercise 3-4 Drawing a Conference Room Using Polar Tracking
- Polar Tracking
- Polyline Edit
- Specifying Points with Tracking
- Drawing the Chairs around the Conference Table
- Completing the Conference Room
- Using Command Preview
- Choosing Selection Options
This chapter is from the book
This chapter is from the book
This chapter is from the book
Completing the Conference Room
Finish the conference room by adding a lectern, projector screen, and cabinet. Add additional chairs and hatch the walls as shown in Figure 3-53.
Step 32. Draw the 24″ × 20″ lectern as shown in Figure 3-53.
Step 33. Set layer i-eqpm-ovhd current.
Step 34. Add the 96″ × 3″ recessed projection screen and the 24″ × 24″ ceiling-mounted projector to the plan as shown in Figure 3-53. Locating the 96″ × 3″ recessed projection screen will require use of the x, y, z-filters and the Mid Between 2 Points option of the Osnap menu. Ask your instructor to demonstrate it in class.
Step 35. Make the following new layers and draw the lines for the built-in upper and lower cabinets, as shown in Figure 3-53:
Layer name
Color
Linetype
Lineweight
a-flor-case
green
continuous
.006″ (.15 mm)
a-flor-case-uppr
red
hidden line
.004″ (.09 mm)
Step 36. Copy and rotate the two extra chairs in the room, as shown in Figure 3-53.
Step 37. Create the following new layer and set it as the current layer:
Layer name
Color
Linetype
Lineweight
a-wall-patt-gray
gray (253)
continuous
.004″ (.09 mm)
Step 38. Use the HATCH command to make the walls solid, as shown in Figure 3-53.
Step 39. Set layer a-anno-text current.
Step 40. Use the Single Line Text command (type DT <Enter>) to type your name, class number, and date, 6″ high in the upper-right corner (Figure 3-54).
Step 41. When you have completed Exercise 3-4 (Figure 3-54), save your work in at least two places.
Step 42. Print your drawing from the Model tab at a scale of 1/4″ = 1′-0″.
Figure 3-54 Exercise 3-4 complete
)
){kind=link}